Snap-N-Seal one piece compression connectors

 ***Local Pickup available at Whateveryouwant.ca at 65 Bently Ave, Ottawa.***

Learn More

For Dish Network receivers! Must use a DPP Twin LNB or DPP44 switch in combination with this item. The DP Separator will not work with a standard DISH Pro Twin or Legacy LNB. When used with a DPP Twin or DPP44 the separator enables you to run 1 cable into the home and feed dual tuner DISH Pro Receivers (322, 522, 612, 622, 625, 721, 722, 921 and 942) making installations a snap.

Learn More

Designed to be used with the DISH 500 Antenna or Bell Expressvu. Use to capture signals from both Dish Network satellites (119º and 110º) OR use it to capture signals from both Bell ExpressVu satellites (92º and 81º). 22 KHz switches are built-in and weather-proof. Supports ONE or TWO, THREE OR FOUR DISH Network *Dish PRO satellite receivers.

Learn More

50 Thomas & Betts RG6 Snap-N-Seal connectors SNS1P6 Learn More

• Works with RG6 coaxial cable (60% thru Quad)

• Compression

Learn More

-          Built to SCTE Standards

-          Capacitive coupled F-ports prevent RF hum modulation

-          Machined F-Ports pressured sealed

-          Zinc die cast housing back cover

-          Soldered back plate fοr EMI shielding

Learn More

- superior conductivity

- corrosion resistant

- 3Ghz

- Blue center

Approved with many Sat and Cable companies

Learn More

 Snap-N-Seal one piece compression connectors

Learn More

It works with all circular polarization ku band satellites. Great choice for Echostar 3 (Dishnetwork 61.5), Echostar 6/8 (Dishnetwork 110), Echostar 7 (Dishnetwork 119), Echostar 1/2 (Dishnetwork 148), All DirecTV, All Bell ExpressVu and other
Linear Polarity satellites.

It works with all FTA satellite receivers, such as Pansat, Fortec, Coolsat, Digiwave, dreambox; it also works with all Dishnetwork or BellExpressVu receivers. Learn More